Обновился до версии 3.64 с сайта производителя. На одной фазе зависает постоянное значение 7040W - написал в службу поддержки, прислали старые прошивки для установки, в выходные буду тестить. Я также поинтересовался значениями параметров, вот что они прислали, может кому понадобится:
Parameter 3, set to 0
Parameter 12, set to 0 (if you are using USB power)
Parameter 101, set to 2319 (This will report KWH, Watt for clamp 1 and the total HEM)
Parameter 111, set to 240 (You can set this to whatever you want, this will set the interval of reporting parameter 101, so 240 is 240 seconds or 4 minutes)
If you want to, you can set parameter 111 to any interval you want, though i would advise against real time reporting, you should keep the reports at 30 seconds or higher regardless of being on USB or battery.