Я тоже об этом читал, но все же надеялся, что это не так. Не очень удобно, конечно.
Меня смутило описание уведомлений в мануале:
Z-WaveTM Message Report
* Motion Report:
When the PIR motion detected, the device will unsolicited to send the “Sensor Binary Report” to the nodes in the group 1.
Sensor Type: Motion (0x0C)
Sensor Value: 0xFF
* Door/Window Report:
When the Door/Window state changed, the device will unsolicited to send the “Sensor Binary Report” to the nodes in the group 1.
Sensor Type: Door/Window (0x0A)
Sensor Value: 0x00 is closed, 0xFF is opened.
* Tamper Report:
When the 2 tamper keys in the device are pressed over 5 seconds. The device will into the alarm state. In that state, if any one of the tamper keys be released, the device will unsolicited to send the “Sensor Binary Report” to the nodes in the group 1.
Sensor Type: Tamper (0x08) Sensor Value: 0xFF
* Temperature Report:
When the PIR motion detected or the door/window state changed, the device will unsolicited to send the “Sensor Multilevel Report” to the nodes in the group 1.
Sensor Type: Temperature (0x01)
Note: To disable this functionality by setting the configuration setting N0.5, the bit5 of the value to 1.